Networking :: Wireless And Ethernet Show Yellow Triangle Over Icon BUT Both Work
Dec 20, 2015
I have several computers, one laptop recently has a new problem. The internet network connection in the corner has a tiny yellow triangle and says the connection is limited and says it is NOT connected to the internet - even though it IS connected to the internet. It does this for both the wireless icon and the ethernet icon, so it can't be a driver issue.
I have rolled back the drivers, gone to the HP support site to get their drivers, updated to the latest drivers, and nothing gets rid of those triangles.
It's also not a router issue, because I have another computer on the same router with no problem on either the wifi or ethernet. I've done sfc /scannow in both safe mode and normal mode. I've looked for any errors and there are none. It is very annoying.
View 3 Replies
Similar Messages:
Nov 22, 2015
I just upgraded from Windows 8.1 to 10 and having this annoying issue where the yellow triangle over the ethernet icon in the taskbar will not go away. I can get online and surf so not sure whats going on. I did install the new lan drivers but still getting the annoying yellow triangle .
View 9 Replies
Aug 8, 2015
Last night I bit the bullet again & upgraded to windows 10 & then did a clean install. I have noticed that the network icon in the system tray shows a yellow triangle & says no access but I can surf fine with chrome & use qbitorrent etc.
The only way I can get rid of the yellow triangle is to disable the network adapter & then re enable it.
Not using any third party firewall as private fireall doesn't support windows 10.
View 5 Replies
Feb 10, 2016
Basically, last week I bought this laptop And I started off working fine until a few days ago when my internet went off. The wifi logo has a little yellow triangle warning sign next to it and it says Limited. I started off by resetting my wifi but that didn't work then I tried connecting to my iPhone hotspot and that didn't work either and was also saying Limited!! It's obviously not the wifi but the laptop that is the problem. How can I fix this?
View 9 Replies
Jan 15, 2016
I'm on Windows 10 x64 and my network device is a Intel GbE LAN chip (10/100/1000 Mbit).
My issue is : I have a yellow triangle over the network icon in the notification area and it says me "Network : No Internet" even if i can access to internet and my network works perfectly.
That's not very serious issue but that's disturbing to know if i'm connected or not (real disconnections can happen). After trying to reboot my rooter and uninstalling/reinstalling Intel's newest drivers i don't know what to do.
View 9 Replies
Nov 19, 2015
One of my PC's aren't connecting to the internet. It's running Windows 10. And it shows a yellow triangle and says 'no internet' if I click it.
View 1 Replies
Dec 24, 2015
This didn't happen right away. They worked fine for a month or so. It is not the ISP, my ISP is very reliable, they consistently give me the bandwidth I am supposed to get. 20MB down 2MB up. The problem laptop averages 0.3MB down and 1.5MB up.
The other hosts on my home network are not having any problems. I have another Win 10 Machine that was upgraded from Win 7 that is working just fine. One Ubuntu client and one more Win 7 client.
Fixes I attempted:
I went to the HP website and applied the recommended updates.
Checked Microsoft updates - none were suggested or required.
I removed and readded the network adapter drivers. Several times.
The hardware in question is:
HP Envy 17t Laptop
OS: Windows 10 Pro Version 1511 (OS Build 10586.36)
Wireless:Broadcom BCM43142 802.11 bgn Wi-Fi Adapter driver: 6.223.215.14
Ethernet:Realtek PCIe GBE Family Controller Adapter driver: 10.1.505.2015
View 6 Replies
Jul 30, 2015
For those looking, the solution is here: Remove yellow/blue shield icon from shortcuts
After upgrading from windows 7, some of my desktop shortcuts have this shield icon graffiti sullying their lovely visages. Can I remove these somehow?
View 9 Replies
May 13, 2015
I have installed Windows 10 on a new clean hard drive because the old one with Windows 8 died but the new one with Windows 10 wont show any wireless connections. By the way the computer I'm typing on is Windows 10.
View 1 Replies
Jan 27, 2016
I just got my first PC today and I'm a bit of noob. I tried to connect to the internet but noticed that there simply was no option to connect to a wireless network. A wired network works fine though. I checked on the internet. I have a gigabyte z170x gaming 7 as my motherboard. URL....
View 1 Replies
Jul 30, 2015
I recently upgraded from windows 7 to windows 10. My mouse worked fine in windows 7, but it does not work in windows 10. Without my mouse to work with, I am lost on the computer.
Information from the Control Panel (System) is as follows:
HP pavilion dv5 notebooselectk PC , windows 10 Home , 64-bit operating system .
The mouse that I have is a Rocketfish Nano Laptop Optical Mouse.
Information from the Control Panel (Harware and Sound) (Devises and Printers) shows an icon
of the RF Nano Laptop Optical Mouse.
When I select the icon , there is information at the bottom of the page that reads:
RF Nano Laptop Optical Mouse Status: Driver error
Model: Rf Nano Laptop Optic...
Category: Mouse
Status: Needs troubleshooting
More info from the Control Panel (Hardware and Sound) (Devises and Printers) is taken from the Mouse link.
The (Hardware tab) in the Mouse link shows two different types of mouse.
One is a Pluralinput Mouse 0.8.2.0 and the other is a Synaptics P/S2 Port Touch Pad.
The Pluralinput information reads:
Manufacturer : Pluralinput
Location : on RF Nano Laptop Optical Mouse
Devise status : This devise cannot start (Code 10)
View 5 Replies
Aug 17, 2015
I upgraded from Windows 7 Pro and find that the 'Show Desktop' rectangular space at the far right side of the notification area is missing although posted desktop images Windows 10 have the same rectangular space. However, if I hover the cursor over the screen border in that area for about 5 seconds the desktop appears and if I click on the border it remains otherwise it reverts to the previous screen. So, I assume that the 'Show Desktop' functionality is working OK even though the rectangular space is missing. How to restore the rectangular space?
View 3 Replies
Nov 18, 2015
i recently updated to windows 10. I'm having some difficulties regarding internet through Ethernet on It. what usually happens is i am able to surf the Ethernet for around 10 minutes, then the ethernet adapter just quits on me. So i run the network trouble shooter and find you that it needs to reset the DNS, which it does successfully. After that my Ethernet doesn't work anymore till I restart the Laptop. my computer's wifi card is an intel wireless n 7260, and the other network adapter is a pcie gbe family controller.
View 2 Replies
Dec 30, 2015
So i recently updated to windows 10, and i noticed i wasn't connected to my Ethernet anymore, so i had to connect my PC to the wifi. Under my "network Adapters" it only shows "Qualcomm Atheros 802.11 1/b/g/n" I tried connecting another ethernet cable, but nothing happened.
View 1 Replies
Jan 11, 2016
I cannot seem to connect on Ethernet though Wi-Fi works OK. I have seen several articles about ethernet problems with Win10.
CABLING
First the network config:
Two notebooks, C and D are plugged into a switch and the switch plugged into the router. Now, the cabling is verified to work because computer C, running Win7 connects just fine and if the internet cables are swapped, computer C still connects just fine.
Computer D however does not connect. I did some other things to redundantly check too, just FYI.
So cabling looks OK.
ROUTER
both computers have fixed (reserved) IP addresses in the router.
The router sees computer C
but not computer D
Just FYI, if I turn on Wi-Fi, the router sees D on WiFi, but not the ethernet.
PING
Computer C can ping D
Computer D can ping C
Computer C can ping the router
Computer D cannot ping the router
Some investigation suggested the following, all of which I tried with no better results:
- Update the network adapter drivers (already current)
- Winsock posible culprit, so NETSH WINSOCK RESET and reboot - no change
IE used to find and fix these things pretty well, but here we have EDGE. Perhaps I'll try to install IE. Connectivity diagnostics are where IE shined over Chrome and Mozilla.
UPDATE: IE 9, 10, etc. are not compatible with Windows 10. So, the connectivity diagnostics just not as good in Win10. I can tell I am getting tired, as it's getting hard not to swear.
UPDATE: Added a pretty picture.
View 9 Replies
Oct 11, 2015
Yooooo! I have a Lenovo Y510p with modified BIOS so I could replace the crappy Intel wireless card that came with it (Intel Centrino N2230) for an Azurewave - Broadcom 4352. The experience has been good so far, the only problem I'm having is the low wireless signal with the card. I have other laptops that have higher range and strengths on the same place with older cards.
I've tried verifying (and even swapping) the cables and noted no difference. I asked on another forum and they told me that it could be that the card is not receiving enough power, but I have yet to find a settings in the BIOS or in Windows that dwindles its performance. I have recently updated the driver from Lenovo's website and it didn't improve a bit. How to improve the wireless signal?
View 9 Replies
Aug 23, 2015
I was wondering if it's possible to utilize both WiFi and ethernet in tandem. I'm pretty sure some of you are going to tell me that I can only access the internet through one of these, up to my bandwidth limit, but that's not what I mean.
I'd like to access the internet through my WiFi connection, yet have a wired connection through my router to access the files on the other computers in my house.
View 1 Replies
Jan 18, 2016
I am running Windows 10 demo version. I have problems connecting to the net. I am shown the error along the lines of "Ethernet does not have a valid IP configuration".
From command prompt I run "ipconfig/all" and here is the console's output:
When I run "ipconfig/renew" it fell through : I should add, I have no problems on Windows Vista however.
View 4 Replies
Nov 27, 2015
I ran Windows 8.1 on my desktop machine a few months ago, and later upgraded to Windows 10. Everything worked great at that time, but since have replaced Windows with Linux. Now I'm trying to install Windows again, with the same 8.1 disk that I used for my earlier installation, and my ethernet connection isn't found. (this is a direct wired ethernet, not wireless) I've installed with a local user account, dug into every networking utility in Windows, but whatever I do the internet goes undetected. I've run the ethernet thru different routers, and even circumvented the router all-together, but no luck. Has my 8.1 disk "expired"?
View 3 Replies
Dec 9, 2015
I started my PC in a new premises with a Wireless modem, I have two other PC's connected.
When I started the PC it saw the wireless network and the option came up to connect and there was a tick in the "Connect Automatically" box.
I selected OK but got a message "unable to connect".
I did not get the opportunity to enter the Password/Key.
Now the PC will not connect to the Network nor will and Diagnose and repair fix anything.
BTW the Ethernet adaptor has been disabled.
The laptop I am sending this from is next to the PC so the wireless signal is okay.
View 4 Replies
Oct 11, 2015
I've been having problems with my network drives which seems to have happened after a recent Windows 10 'update'
In device manager I stupidly deleted a number of Windows adaptors under the Gigabit network connection.
Now I just have the Red Cross over the Internet icon.
Ive tried reinstalling Intel drivers but they stop at 'installing network drivers for Intel 82579v Gigabit network connection'
I then get a message 'cannot install drivers - No Intel (R) adaptors are present in this computer'
motherboard is is a Gigabyte X79 UD3 running F20 Bios. The network adaptor is onboard.
I can't seem to figure out why the computer can't detect the adaptor.
There is no ethernet controller in the device manager? And the network and internet page in settings does not give an Ethernet connection option?
View 2 Replies
Nov 5, 2015
i've been with this problem for months and i have tried multiple solutions offered by others on the internet, yet i'll give it another try here.
i'm using a powerline adapter directly plugged into the wall on my desktop. And it has worked excellent before, but suddenly someday it did not get a valid IP adress anymore for my pc, i have tried giving it an ip adress manually but without succes. i also tried updating the driver but there was no update.
my network and sharing center displays unidentified network and windows problem solver detects the problem 'network name' does not have a valid ip configuration.
View 9 Replies
Feb 10, 2016
I have just bought an HP laptop running windows 10. I cannot connect to internet wirelessly as when I select my network connection it requests username and password. (Screen shot attached)I only have a network password for my connection and have never had or been requested for a username.
We have a couple of laptops at home and they connect with password only no problem. It is only this laptop that requests both. I can find no way past it and cannot connect. It connects via cable fine but thats obviously not ideal for portable laptop.
View 9 Replies
Sep 16, 2015
We have a new (albeit old) wireless printer (HP Color laserjet CP3525) with a wireless adapter card. Computers running Windows 7 or Windows 8 could see the network and connect. All computers could then print to the printer. None of our computers running Windows 8.1 could see the network. I upgraded one computer to Windows 10. It can now see the printer network but cannot connect.
View 7 Replies
Aug 20, 2015
When I first installed Win 10 it was working great got my wifi connection working and everything now it seems I cannot get connected. I have tried several times, putting it mildly. I put in the Modem/router address and password and then I go to the site that shows you the wifi connections and mine is not there. But there are about 10 or 12 that are there. I have tried this several times like I said. And I have rebooted to see if that did anything and it made no diff.
It seems from some of the reading I have done this might be a problem caused by an update. It worked great for several days. And while I am thinking of it can you delete all those other wi fi addresses some how.
View 19 Replies
Jan 10, 2016
So I've got a simple question really when a laptop is connected to a WIFI network then a Ethernet connection is plugged in which one will it use as priority?
View 3 Replies
