Screen Backlight Still On When Screen Turned Off HP Elitepad?
Aug 11, 2015I have an HP Elitepad 900. The problem I seem to have is when I press the power button to turn off the screen, the screen turns off but the backlight stays on.
View 2 RepliesI have an HP Elitepad 900. The problem I seem to have is when I press the power button to turn off the screen, the screen turns off but the backlight stays on.
View 2 RepliesI recently updated my DELL L502X to Windows 10 from Windows 7. All drivers have been installed and Device Manager shows no problem. However I'm seeing a weird issue. I'm using an external monitor (ASUS) through HDMI. I'm setting the display to show on external monitor only. In Windows 7, everything works fine. After the Windows boot logo disappears, laptop screen turns off and external monitor turns on. In Windows 10, however, there is an issue.
After boot logo disappears, external monitor turns on, and laptop screen turns off - but not completely. There is no content anymore but the back light is still on. If I switch the display mode to Duplicate or Extend (just to turn on the laptop screen) and switch back to Second Monitor Only, the laptop screen can turn off completely.
Both monitors are shown as Generic PnP Monitors in Device Manager. I don't know if this is a driver problem or something related to my laptop. The bottom line is in Windows 7 there is no such a problem.
I have a PC with the following configuration:
Intel Core I5-4460 Haswell 3.2GHz
GIGABYTE GA-Z97-D3HKingston
HyperX Fury Blu 1x8GB DDR3 1866MHz CL10 1.5V
Kingston SSDNow V300 240GB + SAMSUNG Spinpoint F1 HD753LJ 750GB
SeaSonic S12II Bronze 620W
Cooler Master Haf 912 Compact
I always used to set the turn off display after 2 or 3 minutes, everything was working fine with my old PC but after the new PC whenever the screen is turned off i can't turn it on again buy using the mouse or keyboard.
This problem was while using windows 8.1 and after installing windows 10 pro the problem is still there.
Tried turn off hibernate solution but with no luck.
Connection with monitor is throw HDMI cable with the internal Intel 4600 VGA Card
This morning I turned on my HP All In One and the screen stays black. I had 10220 loaded but I don't know what happened until I went to this forum on my other system and discovered 10240 was released.
View 7 RepliesWhile using PowerPlanner7, I believe I may have accidentally turned off display or brightness to 0. I am unsure if I successfully made it back to the desktop after rebooting(my attempt to solve the problem). I have tried searching the Internet for shortcuts that re-enable screen or turn brightness up(my keyboard brightness buttons do not work since I am on Mac and the functions keys are all remapped- holding fn then function is same as just pressing function now too)
View 5 RepliesRecently I downloaded a program but it came with a ton of malware. I booted my laptop in safe mode and ran a bunch of malware removal programs. When I tried to boot my computer back up, the screen lit up and turned grey.
View 1 RepliesMy screen saver does not work when my computer is turned on. I have to "restart" it and then the screen saver works.
I have not added anything or changed anything and all of a sudden for the past four days this has cropped up.
I have the bare minimum items in my start up folder.
So I have a bit of a problem where my screen flashes, I instantly thought it was display drivers so I uninstalled them only to worsen the problem, the computer restarted with a black screen which later turned into a desktop screen with no icons and a flashing screen (can't click anything or even load up the start menu with the windows key). I put it into safe mode but it does the same thing. Nothing works except task manager and i can't run task from it or it will exit out, system restore doesn't fix the issue either. Computer is a lenovo k450 i5-4440 8gb ram 1tb hdd with an evga gtx 760.
View 1 RepliesUpgraded my system to Windows 10 from 8.1. ASRock Z170 Gaming K4, i7-6700k, 16Gb DDR4, GTX980Ti, 958.87 Win 10 drivers (was using the same version win 8.1 driver) 3 Asus 24" monitors connected with display port to HDMI cables.
After a few minutes of not touching the keyboard or mouse, the monitors appear to have the signal stop being sent but I can see the LED backlights are still on so the screens have a glow, they are not black. As I have a TV tuner card in my system and usually have one monitor showing TV having all 3 screens lose the signal from the video card is a pain. Power setting is set to turn screens off after an hour of inactivity but this issue seems to be the video signal getting shut down.
So is this a Windows 10 or nVidia driver issue? Did not do this with 8.1 with the same driver version.
I have an Insignia 8" tablet that I use to listen to an internet radio station. WiFi connection to my 2Wire 3801HGV router. I have it powered by the AC charger. I have the display to turn off after 5 minutes, never to go into sleep mode when powered by AC. After the 5 minutes the display is turned off, the music continues as expected and will continue for hours. But if I try to do anything I loose my WiFi.Right after the screen is shut off I can enable it again with a stroke. Then the music stops. I no longer have internet access.
Network settings says I still am connected but somewhere the connection is broken. I disconnect from my router and then try to reconnect and it will not. I get, Checking Network Requirements, Can't connect to this Network. The only way I have been able to get connected is to do a restart. I have not found any settings that have been useful. All it should be doing is shutting off the screen. Not go into any other sleep or power down state.
I did a bit of research and this seems to have been an issue for a while, or has been in the past. Was upgrading to windows 10, I first had to restart my pc cause it was initially stuck on that preparing to install problem with the green bar being stuck around 25%.
It then got through that and began the installation process with the big circle and rebooting process. However around 91% when I last looked at it it was just black screen, this stayed this way for about 3-4 hours. I then decided to reboot the pc and it has now booted to the login screen. Is this a known bug or could there be a possible issue?
The problem seems a bit different as some people I saw have had to fall back on PC restore points etc. So not sure if it installed or what could be the problem.
Also side note, I upgraded my pc when windows 10 first publically released, but rolled back because I had about 5min shutdown times.
I have a Lenovo Thinkpad Edge with an Intel I5 processor, 64 bit with no hardware upgrades (stock). I had accidentally stepped on the screen (fell off my lap and then crunch) which was mangled beyond repair, so I have been using it similar to a tower, with a VGA and/or HDMI connected monitor (my HDMI cable went bad, I picked up a new cable but hadn't hooked it up to the second monitor. I started my free upgrade from Windows 7 Home Premium to 10 last night. I woke up to the black screen/mouse pointer issue which is what brought me to this thread. I tried the recommended fix:
1. Hit ctrl, type in password and enter
2. Win Key + P + Down Arrow. (Win Key + P only seems to do the same thing)
This brought up options to
1. Disconnect projector (Tried this and lost connection to the VGA even after reboot)
2. Duplicate (Screen is still black with mouse cursor, but I saw a little bit of red and blue pixels at the bottom where the task bar should be until I disconnected and re-connected the VGA, then it was back to black screen and cursor)
3. Extend (still black screen and cursor)
4. Connect Projector (still black screen and cursor)
I'm not sure what to do. I must have some OS installed, because I am able to also perform these operations from my USB Keyboard/Mouse. I'm just not sure how to get Windows back on my VGA connection (I haven't tried HDMI because I did not have it connected when I ran the update.) I thought Duplicate displays would do the trick, but apparently not. For as beat up as the laptop is on the outside, the hardware performs fine. I also have a 2nd laptop (work laptop, also a Lenovo W541) that I can use if any solution involves downloading something bootable.
Since upgrading to Windows 10 from 7, I ran into the same issue as [URL] ....
So I tried the catalyst scaling option for my desktop and this seemed to fix the issue for mostly everything, desktop and most games, However, the problem still seems to arise with some games I try to play, such as Xcom Enemy Within or Dawn of War 2. Changing resolution in these games doesn't appear to have any effect, the image is still falling off the screen, I use my desktop on a 32 inch TV as opposed to a monitor via HDMI, and keep it set to 1600x900 as opposed to its native 1920x10180, but even leaving it at 1920 has the same effect.
I have my specs on a dxdiag file, dunno where to upload it here, but I'm using a AMD Radeon R9 200 Series on an Asus I built.
I upgraded to Win 10 on Friday, and since, despite several resetting PC attempts, Win 10 will not load to the login screen. Instead, it is stuck on a loop flashing between the lock screen and a gray loading screen quickly back to the lock screen -- instead of loading to the login screen. This only happens when I attempt to restart or update my PC. If I go to the lock screen because I locked my PC or it fell asleep, I can unlock it. I have also attempted to reset my PC to the previous build, to no avail. I have no restore points.
View 1 RepliesWhen I boot up my computer (to windows 10). It will do the Asus splash screen then instead of going straight to windows if does this black screen with the kinda terminal thing (with no writing/text) then goes on to windows. Does this affect my computer?
View 1 Replieswin10 after showing logo black screen take 2 to 3 mintus to show welcome screen. amd radeon dual graphic card 7400+6310 driver amd site shows it a latest updated driver ...
View 2 RepliesI reinstalled windows the day before yesterday and since then every time I turn my laptop on after entering my password the screen turns off for like 2 seconds then turns back on. This have never happened to me before. I tried putting my old windows back via Macrium Reflect and I even tried reinstalling it again but neither of those things worked. I have an Acer Aspire V3-572g laptop.
View 9 RepliesSince the latest update (It introduced the slide show of pictures on the lock screen. I think it is KB3124200) I haven't been able to press Enter or Space or any other key for that matter to "slide up" the lock screen photo to get to the password screen. I've looked through the lock screen settings, but I see nothing that could prevent this.
View 2 RepliesI upgraded from Windows 8 to 10 without a hitch an hour ago and kept all of my personal files and apps. I set up my start menu and everything was working fine, but I wanted to change the image on the logon screen (or whatever you call the screen in between the lock screen and the screen where you enter your PIN/info). So I took a risk and downloaded the 3rd party app here:
[URL] and uploaded an image and hit apply. Of course right after doing that I went to lock my PC to see if it worked, and as you can tell... it didn't.
I've tried rebooting and it hasn't worked. It's just very rapidly flashing between a blue screen w/ a loading circle and my lock screen image.
I upgraded to Windows 10. The entire screen shows up in about 75% of my monitor with the rest black. It's not that the fonts are too small, it's just that it makes my monitor look a lot smaller and I cannot seem to get it to fill up the entire monitor like Windows 8.
View 1 RepliesI have an AMD 6670 and I just upgraded to Windows 10. At first I couldn't set my resolution back to 1920x1080 but I downloaded the driver and now I'm able to. The issue is that when I set the resolution, it's like everything is stretched out. The taskbar is off the screen on the bottom and same with the icons on the top and sides of the screen. I can see the very top of the taskbar at the bottom, but not enough to click on start or choose any programs that I have open.
View 1 RepliesHave the above laptop and when trying to upgrade from Windows 10 I get the dreaded black screen problem.I get to 85% after I few reboots and it hangs at that point. No cursor on screen,clt alt del not working nothing,just blank screen no hdd movement. I tried plugging laptop into TV by hdmi still no screen. Power of laptop and previous version of windows reinstalled.
View 1 RepliesThis might be a stupid question but I havent found a solution for it myself, probably looking in all the wrong places.. would like to be able to have my computer go to the lock screen after an alotted time of inactivity without turning off the screen itself as in the power settings. I usually have screen shutoff/sleep set for longer periods but would like the screen to lock sooner.
View 9 RepliesOkay so I updated from windows 7 to windows 10 i have these black bars around my screen instead of a full screen so I tried changing the resolution because it was set to 800x600 so I change it to 1920x1080.
View 1 RepliesThe black screen occurs before login screen. It happens randomly. I have to move the mouse (haven't tried pressing keyboard) and it will show the login screen and windows will continue normally. On my device driver it shows only 1 display adapter that is NVIDIA GTX 970. My motherboard is H87-PLUS and its specs shows that it does have an Integrated Graphics Processor.
Tried installing Intel Graphics Driver but just shows 'This computer does not meet the minimum requirements for installing this software.' Tried disabling the lock screen too but its not working. Tried putting PCI-E as the default graphics in BIOS but its not working either. how could I prevent the black screen from showing up again?
I came home from shopping and turned on my custom built desktop PC and it gave me a BSOD. On the screen it said "system thread exception not handled". This only happened once
DIN-PC-10_10_2015_190348_82.zip
System Spec
Computer type: PC/DesktopSystem
Manufacturer/Model Number: Custom built
OS: Windows 10 64 bit Home
CPU: Intel i7 3770k (not overclocked)
Motherboard: ASUS P8Z77-V
Memory: Corsair 16GB
[Code] ....